![]() To have our NAT rules restored on boot, we edit the rc. Usually, the easiest is to put those commands into the /etc/rc.local script. Linux provides us with a number of ways to run commands on boot. Save the current rules to a file with this command: language:bash To fix this, we need these NAT rules to be applied each time it starts up. This will work for now, but on reboot, the Pi will revert back to its previous state. This is so I can avoid any need for an internet connection. I would like to make it a portable machine by creating its own access point and then having a VNC into it. Sudo iptables -A FORWARD -i wlan0 -o eth0 -j ACCEPT Hello everyone Recently I have installed kali linux on my raspberry pi (2). Sudo iptables -A FORWARD -i eth0 -o wlan0 -m state -state RELATED,ESTABLISHED -j ACCEPT Sudo iptables -t nat -A POSTROUTING -o eth0 -j MASQUERADE In the terminal, enter the following: language:bash Save and exit by pressing ctrl + x and y when prompted.įinally, we need to configure Network Address Translation (NAT) between the Ethernet and WiFi interfaces to allow devices on both networks to communicate with each other. Your terminal window should look similar to the image below. Remember that 192.168.5.1 is reserved for the Pi. ![]() ![]() On the Raspberry Pi 3 running Kali Rolling, some Kali Linux tools can be. ![]() Note that we set up DHCP to assign addresses to devices between 192.168.5.100 and 192.168.5.200. A Rouge AP is an AP (Access Point) created by the attacker to replicate the AP. In the blank file, paste in the text below. Its not the most powerful thing in the world, but it does work. After saving it, open a new one for editing: language:bash If you turn your Raspberry Pi into a wireless access point, you can make it act as a router. conf file that comes with Dnsmasq has a lot of good information in it, so it might be worthwhile to save it (as a backup) rather than delete it. Dnsmasq will help us automatically assign IP addresses as new devices connect to our network as well as work as a translation between network names and IP addresses. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |